Dynamix UM-S Bedienungsanleitung PDF herunterladen (Seite 23)

Rockwell Automation Publication 1441-UM005A-EN-P - May 2011 23

Time Recorder Extension Module Chapter 2

Save a Time Recorder Setup and Measurement

The time recorder set-up parameters and recorded time waveforms can be saved

to a file that can then be recalled at a later time. The recorded time waveforms are

stored in a .wav file format, and the last block of the recorded .wav file is saved in a

comma separated value (.csv) file format.

You can review .csv time waveform files in the field with the data collector from

the Recorder - Review Data screen. The time waveform .wav audio files can be

imported into vibration analysis software.

You can save a time recorder set-up and measurement anytime the Save function

is displayed on the screen.

Follow these steps to save set-up and measurement data.

1. Press F3 (Save).

The appropriate Recorder - Save screen appears.

IMPORTANT

When data is saved to an SD memory card, only the .wav file is

saved on the card. The .csv file is always saved to the internal

memory in directory: /Mobile Device/Internal Disk/Analyser/

Recorder.

TIP

The Recorder - Save Data screen automatically appears when

the data collector has finished recording the measurement.

Depending where you are in the

process, the Save function either saves

set-up parameters, or saves the set-up

parameters and the recorded data.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Keine Kommentare

Dynamix UM-S Bedienungsanleitung Seite 23