Dynamix 4-Band VDSL CO/CPE Modem Bedienungsanleitung PDF herunterladen (Seite 23)

NVF-800S 4-Band VDSL IP DSLAM USER’S MANUAL

Ver_B.2

3.3 General Rules

Before making any connections to the NVF-800S, note the following rules:

 Ethernet Port (RJ-45)

All network connections to the NVF-800S Ethernet port must be made using Category 5 UTP for 100Mbps and

Category 3, 4 UTP for 10Mbps. No more than 100 meters (about 333 feet) of cabling may be use between

NVF-800S or with HUB or an end node.

 VDSL Port (RJ-11)

All home network connections to the VDSL Port must use 18 ~ 26 gauge with twisted pair phone wiring.

 We do not recommend using 28 Gauge or above phone line.

3.4 NVF-800S Connections

The NVF-800S has 2 x 10/100/1000Mbps Ethernet ports which support connection to 10/100/1000Mbps Giga Ethernet.

The NVF-800S also supports full or half-duplex operation and the transmission mode is auto-negotiation. Therefore,

the devices attached to these ports must support auto-negotiation unless they will always operate at half duplex. If

transmissions must run at full duplex, but the attached device does not support auto-negotiation then one should

upgrade this device to a newer version that supports auto-negotiation and auto-crossover (MDI/MDIX).

3.5 “MDI-X” Station Port Connections

1. Connect the port “9 or 10” on the NVF-800S to any device that uses a standard network interface such as a Cable

bridge, ADSL bridge, Ethernet Switch, workstation, server or to a network interconnection device such as a bridge

or bridge, but depends on the port type implemented.

2. Prepare the network devices one wish to connect. Make sure one have installed suitable VDSL Bridge before

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 156 157

Keine Kommentare

Dynamix 4-Band VDSL CO/CPE Modem Bedienungsanleitung Seite 23